Panasonic

Panasonic 6382 mounting bracket for duct detector

Product code 42440

Mounting bracket (UG bracket) for Uniguard-4 duct detector housing 6377. Used on round and insulated ventilation ducts, where the duct diameter can be as small as 100 mm.

For round and insulated rectangular ducts
Duct diameter from 100 mm
Supplied flat, bent to the shape of the duct
Hole to be drilled in the duct Ø 51 mm
For Uniguard-4 duct detector housing 6377

The product sheet opens in a new tab, where you can print or save it.

A quote or help choosing products? Sales+358 40 668 7641 myynti@pap.fi

A technical question about a device? Technical support+358 40 668 7643 tuki@pap.fi

Product description

Panasonic 6382 is a mounting bracket for the Uniguard-4 duct detector housing (6377). Uniguard-4 detects smoke in ventilation ducts: a venturi tube inserted into the duct leads the airflow to the smoke detector in the housing, and the system works at duct air velocities of 0.5–20 m/s. Normally the foot of the housing is fixed directly to the duct surface, but this is not possible on round and insulated ducts, in which case bracket 6382 is used.

Applications

The bracket is intended for round ventilation ducts and insulated rectangular ducts. When the bracket is used, the duct diameter can be as small as 100 mm.

Installation

The bracket is supplied flat and is easy to bend and shape to fit a round or rectangular duct.

Drill a Ø 51 mm hole in the duct.
Fix the bracket to the duct.
Make sure that the venturi tube has a rubber seal.
Install the Uniguard-4 and the venturi tube on the bracket according to the instructions in the technical description.

The mounting location is chosen as for airflow meters: three duct diameters of straight duct are left before a damper, filter or bend, and five diameters after them.