Emex
MX Power Box power supply unit
Product code 810000
Power supply unit for MX series exit signs and emergency luminaires. MX Power Box supplies the 24 V operating voltage to up to four COM loops, so the luminaires do not load the fire alarm control panel.
- Operating voltage for luminaires on up to four COM loops
- Fuses for each loop (TR5 3.15 A) and fault indicator lights
- Fault output J1 and test input J2 for the fire alarm system
- Adjustable output voltage 26–31.5 V DC, max. 320 W
- Can also be used as an operating voltage line extender
✓ In quote request: pcs ·
✓ On your document list · Select and download documents
The product sheet opens in a new tab, where you can print or save it.
A quote or help choosing products? Sales+358 40 668 7641myynti@pap.fi
A technical question about a device? Technical support+358 40 668 7643tuki@pap.fi
Product description
MX Power Box is a power supply module from Emex for MX series exit signs and emergency luminaires. The luminaires are connected to the COM loop of a Panasonic fire alarm system, but they receive their operating voltage from a separate line. The Power Box converts mains voltage into operating voltage lines for up to four COM loops, allowing a large number of luminaires to be connected to the loops without loading the control panel. The manufacturer recommends a maximum of 35–40 luminaires per operating voltage line.
The power supply unit consists of a rectifier and an interface board. Each loop has its own fuse holder (TR5 3.15 A) and green indicator light, and there are separate LEDs for the 24 V IN and TEST indications. Fault output J1 (CONTROL OUT) is connected to an input of I/O unit 4461/4462, so that the control panel reports a fault if the voltage is lost, a fuse blows or the supply to the power supply unit is interrupted. Via test input J2, the emergency luminaires can be switched on for testing with a relay of the I/O unit. The output voltage is adjustable; for long loops the recommended setting is approximately 31.5 V.
Installation
The Power Box is mounted on the wall. The COM loops from the control panel are connected to the bottom row of the board and the loops going out to the luminaires to the top row (row A outgoing, row B returning). The power supply unit can also be used as an operating voltage line extender, in which case the fault output of each Power Box is connected to its own I/O input.
Technical data
- Product code
- 810000
- Manufacturer
- Emex
- Product group
- Emergency lighting › Power supplies
- Weight
- 4.6 kg
- Dimensions
- 434 × 350 × 83 mm
- IP rating
- IP41
- Operating voltage
- 88–264 V AC (110/230 V AC)
- Operating temperature
- −30…+60 °C
- Standards
- Tested and approved in accordance with EN 55032, EN 61000-3-2 and EN 55024
- Product number (Emex)
- 810000
- Output voltage
- 26–31.5 V DC, adjustable
- Output current
- Max. 11.9 A
- Output power
- Max. 320 W
- Capacity
- 4 COM loops
- Fuses
- TR5 3.15 A, one per loop
- Battery
- No
- Material
- Steel
- Colour
- Light grey
- Storage temperature
- −40…+85 °C
- Humidity
- Max. 95% RH, non-condensing
- Mounting
- Wall mounting
Documents
Original manufacturer documents (PDF).
Technical datasheets
Certificates and declarations
Need help choosing products?
Our sales team will help you choose devices that suit the site and the existing system, and will prepare a quotation. Tell us about the system, the site and the quantities needed.